MR6292

AC/DC current probe model MR6292 is an accessory for the AEMC® Micro-ohmmeter model 6292. This probe is required for using the Model 6292 to take measurements in BSG (both sides grounded) mode. This probe is designed to meet the latest safety and performance standards. This probe’s hook-shaped jaws enable you to “pry” into or “hook” onto cables (it will accept 2 x 500 MCM) or small bus bars. This Model MR6292 uses Hall effect technology. All electronics are self-contained in the handle. Probe operates via voltage provided by the Model 6292. The probe has a proportional mV output for direct reading on the Model 6292.

• Protective non-slip guard, green light (ON when connected to the model 6292)
• Working voltage rating of 600Vrms, nominal current of 50A (DC)
• 5ft (1.5m) lead with 4-conductor shielded cable termination with 5-pin XLR connector
• Safety compliance of EN50081-1 Class B, EN50082-2, IEC 1000-4-2, EN 61010-2-32, 600V CAT III
• Output signal of 10mV/A (DC)
• Jaw opening size of 1.2inch
• Maximum cable diameter of (1) 1.18inch or (2) 0.95inch or (2) 1.2inch x 0.4inch (bus bars)
• Load impedance <gt/>100kohm/100pF, Accuracy 1.5%R ± 0.2A
• Dimension is 8.8inch height x 3.82inch width x 1.73inch depth
• Operating temperature range from 14 to 131°F

Avisos

Potentially high voltages and currents may pose a shock hazard. Never exceed the maximum working voltage ratings given. Never open the back of the instrument while connected to any circuit or input.

Notas

No battery is required.