NCV7356D1R2G

NCV7356D1R2G is a single-wire, CAN transceiver. It is a physical layer device for a single wire data link capable of operating with various carrier sense multiple access with collision resolution (CSMA/CR) protocols such as the Bosch controller area network (CAN) version 2.0. This serial data link network is intended for use in applications where a high data rate is not required and a lower data rate can achieve cost reductions in both the physical media components and in the microprocessor and/or dedicated logic devices that use the network. The network shall be able to operate in either the normal data rate mode or a high-speed data download mode for assembly line and service data transfer operations. The high speed mode is only intended to be operational when the bus is attached to an off-board service node. This node shall provide temporary bus electrical loads which facilitate higher speed operation.

• Fully compatible with J2411 single wire CAN specification
• Operating voltage range from 5.0V to 27V, selective BUS wake−up
• Logic inputs compatible with 3.3V and 5V supply systems
• Standby to sleep mode timeout, low RFI due to output wave shaping
• Fully integrated receiver filter, bus terminals short−circuit and transient proof
• Loss of ground protection, protection against load dump, jump start
• Thermal overload and short circuit protection, undervoltage lock out
• AEC-Q100 qualified and PPAP capable, bus short circuit current is 350mA maximum
• Operating junction temperature range from -40°C to +150°C
• 8-lead SOIC package