Low

PACE  1121-0625-P5  Soldering Iron Tip, Conical, 0.76 mm

PACE 1121-0625-P5
Technical Data Sheet (91.83KB) EN See all Technical Docs

The actual product may differ from image shown

Product Overview

The 1121-0625-P5 is a 0.03-inch (ID) x 0.08-inch (OD) Endura Thermo-Drive Desoldering Tip for use in the SX-70 and SX-80 heaters. The inside diameter (ID) of the tip must be large enough to fit over the lead, while providing sufficient room so that air and solder can be drawn through the tip. The outside diameter (OD) of the tip must be slightly smaller than the diameter of the pad to prevent tip contact to the board laminate and minimize the possibility of damage.

 

Product Information

Tip / Nozzle Width:
0.76mm
Tip / Nozzle Style:
Conical
For Use With:
SX-80 Endura Desoldering
Product Range:
-
SVHC:
To Be Advised

Find similar products  grouped by common attribute

Applications

  • Maintenance & Repair

Legislation and Environmental

Authorized Distributor

Substitutes

Soldering Iron Tip, Conical, 0.76 mm

PACE

7 in stock

Price for: Pack of 5

1+ $59.45

Buy

Associated Products

Similar Products

Find products functionally similar to this one. Select one of the following links, and you will be taken to a product group page that presents all products in this category that share the given attribute.