MCBSTM32F200U

MCBSTM32F200U is a Keil MCBSTM32F200 evaluation board with ULINK2 debug adapter which enables to create and test working programs based on the STMicroelectronics STM32 F2xx series of ARM Cortex-M3 processor based devices. The STM32F207IG microcontroller is provided with the MCBSTM32F200 board which is a high end STM32F devices with on chip CAN, Ethernet, USB (full and high speed) connectivity and parallel camera interface. A 25MHz oscillator provides the clock signal for the MCU. The JTAG Interface connector provides debugging and emulator support for the STM32F207IG device. The JTAG Interface allows application debugging and programming of on chip and off chip flash devices. The board connects the on chip serial UART to the ST3232C, which converts the logic signals to RS232 voltage levels. ULINK2 debug adapter connects PC's USB port to target system and allows to program and debug embedded programs on target hardware.

• 120MHz STM32F207IG ARM Cortex-M3 processor based MCU in 176 pin BGA
• On chip memory: 1MB flash & 128KB RAM
• External memory: 8MB NOR flash, 512MB NAND flash, 2MB SRAM, 8KB I2C EEPROM with NFC interface
• 2.4 inch colour QVGA TFT LCD with resistive touch screen
• 10/100 ethernet port, Serial/UART port
• USB 2.0, CAN, MicroSD card interface
• Analog voltage control for ADC input
• Audio CODEC with line in/out and speaker/microphone
• Digital microphone, Digital VGA camera
• 5 position joystick, accelerometer, gyroscope

Applications

Communications & Networking, Motor Drive & Control, Medical, Industrial, Security, Consumer Electronics

Contents

Board, ULINK2 debug adapter, MDK-ARM Lite Edition, USB A to Micro-B cable, uVision IDE Quick Start Guide.