10127818-222LF

The Minitek Pwr 4.2 series Board or Wire-to-Board Connector are designed for power application with current rating up to 9A per circuit. It is available for dual row and 2 to 24 circuits, for wire-to-board, wire-to-wire and wire-to-panel mount application. The crimp, snap-in header and receptacle contacts are used to terminate 28 to 16AWG wires. The header and receptacle housings allow wire-to-wire and wire-to-board configurations. Crimping and removal tools are available for wire harness assembly. Header assemblies for wire-to-board in interconnections include vertical and right angle components. These wave soldering headers are available in through-hole configurations. A right angle version cable receptacle is also available.

• Fully isolated terminals
• Prevents terminals from potential damage during operation
• Positive locking on HSG with low thumb latch operation
• Polarized mating geometry
• Scoop-proof housings
• Fully polarized housings
• High retention force in HSG
• Low insertion force for installation of crimped terminal
• UL94V-0 Flammability
• Vertical and right-angle PCB headers for wave soldering application
• Interchangeable and compatible with Molex Micro-Fit™
• Wire-to-wire, wire-to-board and wire-to-panel connectors with 4.2mm centerline
• Meet environmental, health and safety requirements
• Flexible applications in various situations
• Supports various 1.6mm PCB applications
• Well secures terminals in housings
• Prevents accidental mis-mating
• 1000MΩ Insulation resistance (minimum)
• 10mΩ Contact resistance (maximum)
• 30 Cycles durability
• -40 to 105°C Operating temperature range

Applications

Consumer Electronics, Sensing & Instrumentation, Medical, Lighting, Communications & Networking, Computers & Computer Peripherals, Industrial