MK10FN1M0VLQ12

The MK10FN1M0VLQ12 is a 32-bit Kinetis K1x Baseline Microcontroller based on ARM Cortex-M4 RISC architecture core operates at a maximum frequency of 120MHz. The device incorporates 1024kB internal flash, 128kB internal RAM, four 16-bit SAR A/D converter, two 12-bit D/A converter and 104 general-purpose I/O pins. This device also features communication interfaces like six UART modules, three SPI modules, two I2C modules and two I2S modules.

• ARM Cortex-M4 core with DSP instructions delivering 1.25 Dhrystone MIPS per MHz
• Serial programming interface (EzPort)
• FlexBus external bus interface
• NAND Flash controller interface
• 3 to 32MHz Crystal oscillator and 32kHz Crystal oscillator
• Multi-purpose clock generator
• Multiple low-power modes to provide power optimization based on application requirements
• Memory protection unit with multi-master protection
• 32-channel DMA controller, supporting up to 128 request sources
• External watchdog monitor
• Software watchdog
• Low-leakage wakeup unit
• Hardware CRC module to support fast cyclic redundancy checks
• 128-bit Unique identification (ID) number per chip
• Low-power hardware touch sensor interface (TSI)
• Programmable gain amplifier (PGA) integrated into each ADC
• Four analog comparators (CMP) containing a 6-bit DAC and programmable reference input
• Voltage reference
• Programmable delay block
• Two 8-channel Motor control/general purpose/PWM timers
• Two 2-channel quadrature decoder/general purpose timers
• Periodic interrupt timers and 16-bit Low-power timer
• Carrier modulator transmitter
• Real-time clock
• Two controller area network (CAN) modules

Applications

Industrial