DS2786G+T&R

The DS2786G+T&R is a stand-alone OCV based fuel gauge in 10 pin TDFN package. This device estimates available capacity for rechargeable Li-ion (Li+) and Li+ polymer batteries based on the cell voltage in the open-circuit state following a relaxation period. The open-circuit voltage (OCV) is used to determine relative cell capacity based on a lookup table stored in the IC. This capability makes accurate capacity information available immediately after a battery pack is inserted. The DS2786B uses coulomb counting as a secondary means of estimating relative capacity, remaining capacity is reported in percent along with cell voltage, current and temperature information. Cell characteristics and calculations are stored in on-chip EEPROM. Temperature data is available from an on-die sensor, resistance measurements of a pack identification resistor and pack thermistor are supported by ratiometric measurements on two auxiliary inputs.

• Supply voltage range is 2.5V to 4.5V
• Operating temperature range from -20°C to 70°C
• Measurement and estimated capacity data are accessed through an I2C interface
• Relative capacity calculated from coulomb counter and open-circuit cell voltage (OCV) battery model
• Accurate warning on low battery conditions, low power consumption
• 12bit battery voltage measurement with ±10mV accuracy, 1.22mV LSB (0V to 4.5V) input range
• 11bit bidirectional current measurement with 25µV LSB ±51.2mV dynamic range, 1.67mA LSB at ±3.4A
• Current accumulation measurement resolution ±204.8mVh and ±13.65Ah (RSNS = 15mohm) range
• Internal temperature measurement of 0.125°C LSB, ±3°C accuracy

Applications

Multimedia, Portable Devices, Imaging, Video & Vision, Audio

Notes

ADI products are only authorized (and sold) for use by the customer and are not to be resold or otherwise passed on to any third party