INFS-0010-DC7

The INFS-0010-DC7 is a 6-digit INFINITY® red LED display Strain Gage Meter with four optically isolated open-collector and analogue outputs. It is a microprocessor-based indicator/controller with enhanced features that allow you to easily configure the unit for virtually any application. It is compatible with most strain gage sensors such as load cells and pressure transducers. It can be configured, via the five front-panel pushbuttons to accept any of a variety of DC voltage ranges and display it in engineering units. This meter provides both software and hardware lockout configurations which let you define the parameters, from set-point adjustment to total reprogramming. Users can scale and offset its input signal into any engineering units desired. This is accomplished by the use of an exclusive two-data point method of scale and offset that eliminates the signal errors transmitted from a sensor.

• Wide selection of DC voltage and current ranges
• Ratiometric inputs
• Peak, valley detection and memory
• Large digital offset capabilities enabling easy scaling in engineering units
• Smart filtering detects the difference between a spike or process change
• Single-ended input configuration
• Unipolar/bipolar, programmable polarity
• Dual-slope technique conversion
• Selectable decimal point and read rates of up to 13 readings/sec
• 15-bit Resolution
• ±0.005% Rdg accuracy
• 1sec to 9.9% Step response
• 0.00001 to 500000 Programmable span adjustment
• 50min Warm-up to rated accuracy
• 0 to 50°C Operating temperature range

Applications

Industrial, Metering, Test & Measurement