MCP8026-115E/PT

The MCP8026-115E/PT is a 3-phase Brushless DC (BLDC) Motor Gate Driver with power module, sleep mode and LIN transceiver. The MCP8026 device is power module containing three integrated half-bridge drivers capable of driving three external NMOS/NMOS transistor pairs. The three half-bridge drivers are capable of delivering a peak output current of 0.5A at 12V for driving high-side and low-side NMOS MOSFET transistors. The driver has shoot-through, overcurrent and short-circuit protection. A sleep mode has been added to achieve a typical key-off quiescent current of 5µA. The phase comparator and multiplexer allow for hardware commutation detection. The neutral simulator allows commutation detection without a neutral tap in the motor. The buck converter is capable of delivering 750mW of power for powering a companion microcontroller. The buck regulator may be disabled if not used. The on-board 5 and 12V low-dropout voltage regulators are capable of delivering 30mA of current.

• LIN Transceiver interface - Supports baud rates up to 20Kbaud
• Internal pull-up resistor and diode
• Protected against ground shorts
• Protected against loss of ground
• Automatic thermal shutdown protection
• LIN Bus dominant timeout
• Independent input control for high-side NMOS and low-side NMOS MOSFETs
• Overcurrent and short circuit protection
• Overcurrent comparator with DAC reference
• Neutral simulator
• Buck regulator under-voltage lockout - 4V
• Under-voltage lockout (UVLO) - 5.5V except buck
• Transient (100ms) voltage tolerance - 48V