DS2431P-A1+T

DS2431P-A1+T is a 1024-bit, 1-Wire® EEPROM chip organized as four memory pages of 256bits each. Data is written to an 8-byte scratchpad, verified, and then copied to the EEPROM memory. As a special feature, the four memory pages can individually be write protected or put in EPROM-emulation mode, where bits can only be changed from a 1 to a 0 state. It communicates over the single-conductor 1-wire bus. Communication follows the standard 1-wire protocol. Each device has its own unalterable and unique 64-bit ROM registration number that is factory lasered into the chip. The registration number is used to address the device in a multidrop 1-wire net environment. Applications include automotive sensor identification and calibration data storage, automotive cable assembly identification, and accessory/PCB identification.

• 1024bits of EEPROM memory partitioned into four pages of 256bits
• Switchpoint hysteresis and filtering to optimize performance in the presence of noise
• IEC 1000-4-2 level 4 ESD protection (+8KV contact, +15KV air, typ)
• Reads and writes over a 4.5V to 5.25V voltage range from -40°C to +125°C
• Communicates to host with a single digital signal at 15.4kbps using 1-wire protocol
• Meets AEC-Q100 grade 1 qualification requirements
• Recovery time is 5µs min at RPUP=2.2kohm
• EEPROM programming current is 0.8mA maximum
• 6 TSOC package
• Temperature range from -40°C to +125°C

Notas

ADI products are only authorized (and sold) for use by the customer and are not to be resold or otherwise passed on to any third party