You have entered a value in the highlighted fields below that contain invalid characters. Please revise your selection using valid characters only.
Product may not be an exact match for your search
You previously purchased this product.
View in Order History
DM164120-3
Demo Board Kit, PICKit 2, 28-Pins, PIC16, Generous Prototyping Area, with Two Bare Boards
- Manufacturer:
- MICROCHIP MICROCHIP
- Manufacturer Part No:
- DM164120-3
- Newark Part No.:
- 39M8069
- Technical Datasheet:
- DM164120-3 Datasheet
Product Information
Want to see similar products? Simply select your required attributes below and hit the button ×
- :
- Microchip
- :
- 8bit
- :
- PIC16F8xxx
- :
- PIC
- :
- PIC16
- :
- PIC16F886
- :
- Board
- :
- -
Technical Documents (1)
CAD Downloads
--Please select...
✔
--Please select...
×
Terms and Conditions
CAD Models - Notice
CAD Models and drawings are provided to you on a revocable limited licence for your internal use only but remain the property of the manufacturer who retain all intellectual property rights and ownership. They are provided to assist you in decision making and as design guide but are not guaranteed to be error free, accurate or up to date and is not intended to be taken as advice.
Use of these CAD models and other options provided are downloaded and used entirely at your own risk and by continuing you confirm acceptance of the above.
Product Overview
The DM164120-3 is a small demo board that comes populated with PIC16F886 28 pin microcontroller four LEDs, push button and potentiometer. The demo board has several test points to access the I/O pins of the MCU and a generous prototyping area. The MCU can be programmed with the PICkit 2 Microcontroller Programmer or the MPLAB ICD 2 using the RJ 11 to 6 pin inline adapter. The 28 Pin demo board can be used with virtually any 28 pin dual inline package(DIP) PIC MCU. The assembled 28 Pin demo board comes preprogrammed with a demonstration program. To use this program, power the demo board (3.0VDC to5.5VDC) using a PICkit 2 MCU Programmer. To use the PICkit 2 microcontroller programmer, connect it to a PC USB port using the USB cable. Start the PICkit 2 MCU programmer PC application and click on the target power box to apply power to the demo board. The demo board will blink the LEDs in the Reset pattern.
- The 28 pin demo board can be used with virtually any 28 pin dual inline package
- The assembled 28 pin demo board is populated with a PIC16F886-I/P MCU
- Six pin connector for PICkit serial analyser
Applications
Embedded Design & Development
Contents
Two bare boards, Samples of PIC16F1938 and PIC18F26K22.
Footnotes
The 28 pin board also comes bundled with the PICkit Serial analyser if you order DV164122 (PICkit Serial analyser Kit).
US continental orders over $49 and under 50 pounds may qualify for free ground shipping. Click the link for the full Terms and Conditions of the offer.
No Longer Available
Filter Tool