Customer Q&A Exchange
Ask your questions. Share your answers.
I have several TC201P irons and I just found out they all have the same problem.
Either they have a picture of the OLD EC234 heater or a very bad picture of the NEW version because it looks like a straight cylinder rather than one that flares out quite a bit halfway up.
So, if your heater is a straight cylinder all the way up (TC201P/TC201T) you will need this new barrel nut.
Which is horrible, as when the heater dies in my other iron I will no longer be able to use the DS40/DS60 desoldering attachement I bought just a couple of years back. It just doesn't fit on these new wider diameter heaters! =o.o=;;
Below is a decent picture of both versions:
Newark Part Number:
Like to see information about this product from other customers?