TEKTRONIX  A622  CURRENT PROBE, 50mA to 100A, DC to 100kHz

Technical Data Sheet (1.22MB) EN See all Technical Docs

Image is for illustrative purposes only. Please refer to product description.


Product Overview

The A622 from Tektronix is a 100A AC/DC current probe. This high value current probe is specifically designed to support measurements with Tektronix oscilloscopes. A622 long nose style clamp on probe uses hall effect current sensor to provide voltage output to oscilloscopes. It has a BNC connector and can be used with shrouded banana plug adapter so it can also be used on digital multimeters. It is compatible with TPS2000, TDS1000B, TDS2000C and TDS3000C series oscilloscopes and DMM4020, DMM4040 and DMM4050 digital multimeters.
  • Frequency range from DC to 100KHz
  • Current probe range from 50mA to 100A
  • 10mV/A and 100mV/A output
  • Maximum conductor diameter of 11.8mm (0.46inch)
  • BNC termination
  • Maximum bare wire voltage of 600V (CAT III)
  • UL3111-2-032, CSA1010.2.032, EN61010-2-032, IEC61010-2-032 approved


Product Information

Meter Side Connector:
BNC Plug
Probe Side Connector:
Current Clamp
Current Range Min:
Current Range Max:
For Use With:
Tektronix Digital Multimeters & Oscilloscopes
Product Range:
A600 Series
Current Measuring Range:
50mA to 100A
Current Probe Range:
50 mA to 100 A
Long nose style clamp-on probe provides 10mV or 100mV output for each Amp measured, AC/DC - 100 kHz
To Be Advised

Find similar products  grouped by common attribute


  • Test & Measurement;
  • Power Management;
  • Avionics

Legislation and Environmental

Authorized Distributor

Associated Products

Similar Products

Find products functionally similar to this one. Select one of the following links, and you will be taken to a product group page that presents all products in this category that share the given attribute.