BUSSMANN BY EATON  DRA-1  Fuse Accessory, Adapter, DIN Rail

Manufacturer Part No:
Newark Part No.:
Technical Datasheet:
See all Technical Docs

The actual product may differ from image shown

Product Overview

The DRA-1 is a DIN Rail Adapter for use with Cooper fuse blocks - Edison BM series. Edison DIN rail adapter permits secure, positive snap-on mounting of Edison 0 to 30 amp fuse blocks (one-, two- or three-pole) on various size rails (rail mounting eliminates costly and time consuming drilling, tapping and screw mounting). Adapter mechanically locks into mounting hole of fuse block in seconds to become an integral part of the block. One adapter is required for Edison one- and two-pole blocks. Two adapters are required for three-pole blocks. With the exception of the 32mm DIN rail, all blocks with adapters can be removed from a rail simply by pulling up its release tab.
  • Molded from Lexan® 141
  • Use of rail end-stops on both sides of adapters is recommended


Product Information

Product Range:
RoHS Compliant:
For Use With:
Cooper Fuse Blocks - Edison BM Series
Accessory Type:
DIN Rail Adapter
To Be Advised

Find similar products  grouped by common attribute


  • Safety

Legislation and Environmental

Product Traceability
RoHS Compliant:
Authorized Distributor

Similar Products

Find products functionally similar to this one. Select one of the following links, and you will be taken to a product group page that presents all products in this category that share the given attribute.