Low

BANNER ENGINEERING  OPEJ5QD  SENSOR POWER BLOCK MODULE

BANNER ENGINEERING OPEJ5QD
Technical Data Sheet (2.37MB) EN See all Technical Docs

Image is for illustrative purposes only. Please refer to product description.

Product Overview

The OPEJ5QD is a Power Block Module uses partial phase firing power conversion to enable their wide range of ac input voltage (24 to 250VAC). AC power is applied to the sensor for only a small portion of each AC half-cycle. The current demand during this period may be as high as 1 to 2A per sensor. The collective current demand of several of these sensors on a common AC line is significant. If several sensors are wired directly to the ac mains, it is unlikely that any adverse effects will be noticed. However, problems may be noticed if several sensors are connected to a common circuit that is isolated from the ac mains by a transformer. The collective peak current demand may rob other components on the same circuit of enough power to function properly. In the worst case, a transformer with inadequate reserve current capacity may overheat. Barring a transformer failure, the sensors themselves will operate normally.

 

Product Information

For Use With:
Banner OMNI-BEAM Sensors
Accessory Type:
Power Block
Product Range:
-
RoHS Compliant:
Yes
SVHC:
No SVHC (17-Dec-2015)

Find similar products  grouped by common attribute

Applications

  • Sensing & Instrumentation

Legislation and Environmental

RoHS Compliant:
Yes
Authorized Distributor

Similar Products

Find products functionally similar to this one. Select one of the following links, and you will be taken to a product group page that presents all products in this category that share the given attribute.