Low

K000002 - 

TinkerKit Starter Kit with Multiple Modules

The actual product may differ from image shown

Manufacturer Part No:
K000002
Newark Part No.:
78T2131
Technical Datasheet:
(EN)
See all Technical Docs

Product Information

:
-
:
-
:
-
:
Sensor Shield V.2, 8 Different Sensors and 7 Actuators
:
-
:
-
:
Arduino Boards
:
-
Find similar products Choose and modify the attributes above to find similar products.

Product Overview

The K000002 starter kit is a pack of different TinkerKit modules, aimed to start designing interactive environments/prototype interfaces without using the breadboard or the soldering iron. The kit contains sensor shield v.2 allows you to hook up the TinkerKit sensors and actuators directly to the Arduino, without the use of the breadboard. The kit contains the LDR module a variable resistor (Light falling on the sensor decreases its resistance). The tilt sensor module which can detect when it is at an angle. The thermistor module whose resistance varies significantly with temperature. A potentiometer is a commonly used variable resistor. Turning the knob, you vary the output voltage between 0 and 5V. This value is sent through the middle pin of the pot. The Joystick module is similar to analog joysticks found in gamepads. The Touch sensor that is sensitive to skin contact. The kit also contains button module, linear potentiometer module relay module and LEDs.

Applications

Embedded Design & Development

Contents

Sensor Shield V.2, Button Module, LDR Module, Tilt Module, Thermo Module, Rotary Potentiometer Module, Linear Potentiometer Module, Touch Sensor Module, Joystick Module, Relay Module, 5mm green, yellow red LED modules, 10mm green, yellow red LED modules, 20cm 50cm, 100cm cables.